Menu
Home
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Reply to thread
Click here to become an Official Member of BMW Club Malaysia
Download Form
Home
Forums
BMW Tech and Performance
Interior and Cockpit
Rear view mirror, buttons and red cap funtions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="nagachini" data-source="post: 634008" data-attributes="member: 28789"><p>Programming</p><p>1</p><p>Memory buttons</p><p>2</p><p>LED</p><p>Fixed-code hand-held transmitters</p><p>1. Switch on the ignition, refer to page 42.</p><p>2. When starting operation for the first time: </p><p>Press both outer memory buttons 1 for </p><p>approx. 20 seconds until the LED 2 flashes. </p><p>all stored programs are cleared.</p><p>3. Hold the original hand-held transmitter at a </p><p>distance of approx. 2 to 8 in/5 to 20 cm from </p><p>the memory buttons 1.</p><p>The required distance between the </p><p>hand-held transmitter and the mem-</p><p>ory buttons 1 depends on the system of the </p><p>respective original hand-held transmitter </p><p>used.<</p><p>4. Simultaneously press the transmit key on </p><p>the original hand-held transmitter and the </p><p>desired memory button 1 on the integrated </p><p>universal remote control. The LED 2 flashes </p><p>slowly at first. As soon as the LED 2 flashes </p><p>rapidly, release both buttons. If the LED 2 </p><p>does not flash rapidly after approx. 15 sec-</p><p>onds, alter the distance.</p><p>5. To program other original hand-held trans-</p><p>mitters, repeat steps 3 and 4.</p></blockquote><p></p>
[QUOTE="nagachini, post: 634008, member: 28789"] Programming 1 Memory buttons 2 LED Fixed-code hand-held transmitters 1. Switch on the ignition, refer to page 42. 2. When starting operation for the first time: Press both outer memory buttons 1 for approx. 20 seconds until the LED 2 flashes. all stored programs are cleared. 3. Hold the original hand-held transmitter at a distance of approx. 2 to 8 in/5 to 20 cm from the memory buttons 1. The required distance between the hand-held transmitter and the mem- ory buttons 1 depends on the system of the respective original hand-held transmitter used.< 4. Simultaneously press the transmit key on the original hand-held transmitter and the desired memory button 1 on the integrated universal remote control. The LED 2 flashes slowly at first. As soon as the LED 2 flashes rapidly, release both buttons. If the LED 2 does not flash rapidly after approx. 15 sec- onds, alter the distance. 5. To program other original hand-held trans- mitters, repeat steps 3 and 4. [/QUOTE]
Verification
Post reply
Home
Forums
BMW Tech and Performance
Interior and Cockpit
Rear view mirror, buttons and red cap funtions
Top
Bottom
