Reply to thread

Message: <blockquote data-quote="bd 9229" data-source="post: 491551" data-attributes="member: 21607">Correct me if i m wrong...i remember browsing through the manual care care section..it states that only use clear water in damp cloth to wipe all rubber seal linings etc...it does not encourage any solvent, oil base, luricants etc coz this will accelerate wear tear n cracks on rubber. Considering the cost of getting those rubber change...i prefered the simple tape method.....though it's funny to see the tapes lining bt it sure safe n simple. After 2 over mths..so far so good..hope it will last for sometime before any replacement on the tapes is needed.Hope that helps..bd 9229 :rock:</blockquote>