Menu
Home
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Reply to thread
Click here to become an Official Member of BMW Club Malaysia
Download Form
Home
Forums
BMW Tech and Performance
Interior and Cockpit
Enter sports mode by pulling both paddle shifter
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Ade" data-source="post: 505317" data-attributes="member: 95"><p>the logic gate should be NAND right? Also, you should include some capacitors at the input lines of the NAND gate for debounce purposes. The reset pin on the flip flop should be connected to a capacitor to allow reset to initial position when not in used. Other than that, i think its fine. Time to fabricate and test out! The wires should be at 12V, u will need the voltage dividers. Are you planning a Vcc of 5V?</p></blockquote><p></p>
[QUOTE="Ade, post: 505317, member: 95"] the logic gate should be NAND right? Also, you should include some capacitors at the input lines of the NAND gate for debounce purposes. The reset pin on the flip flop should be connected to a capacitor to allow reset to initial position when not in used. Other than that, i think its fine. Time to fabricate and test out! The wires should be at 12V, u will need the voltage dividers. Are you planning a Vcc of 5V? [/QUOTE]
Verification
Post reply
Home
Forums
BMW Tech and Performance
Interior and Cockpit
Enter sports mode by pulling both paddle shifter
Top
Bottom
