Menu
Home
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Reply to thread
Click here to become an Official Member of BMW Club Malaysia
Download Form
Home
Forums
BMW Tech and Performance
ICE Section
Dynaudio System 240 Mk.II speakers
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="LCP" data-source="post: 184811" data-attributes="member: 2424"><p>Oh wow, what a comprehensive review, thanks Van. I auditioned the System 240 Mk.II (not the 240GT), at Golden here in Penang. The 240 Mk.II is still the current model in the US, but Europe already has System 242. I sure hope those are real Danish butter cookies... I arrived at the same conclusion regarding the neutrality of the MW170, very impressed.</p><p> </p><p>One question, if I were to run them active, do I need the impedance correction circuit recommended by the spec sheet? Here's my plan:</p><p> </p><p>MW170 mid bass: run them with the 22uF capacitor and 3.9ohm resistor shunt as recommended.</p><p> </p><p>MD100 tweeter: use the X250 crossover, set to +2dB, put a 4.7ohm resistor on the woofer output.</p><p> </p><p>With the above circuitry, each amp will see (I hope) a linear impedance across the frequency range, resulting in less chance of weird I-V phase relationship which could make the sound wierd.</p></blockquote><p></p>
[QUOTE="LCP, post: 184811, member: 2424"] Oh wow, what a comprehensive review, thanks Van. I auditioned the System 240 Mk.II (not the 240GT), at Golden here in Penang. The 240 Mk.II is still the current model in the US, but Europe already has System 242. I sure hope those are real Danish butter cookies... I arrived at the same conclusion regarding the neutrality of the MW170, very impressed. One question, if I were to run them active, do I need the impedance correction circuit recommended by the spec sheet? Here's my plan: MW170 mid bass: run them with the 22uF capacitor and 3.9ohm resistor shunt as recommended. MD100 tweeter: use the X250 crossover, set to +2dB, put a 4.7ohm resistor on the woofer output. With the above circuitry, each amp will see (I hope) a linear impedance across the frequency range, resulting in less chance of weird I-V phase relationship which could make the sound wierd. [/QUOTE]
Verification
Post reply
Home
Forums
BMW Tech and Performance
ICE Section
Dynaudio System 240 Mk.II speakers
Top
Bottom
