Menu
Home
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Reply to thread
Click here to become an Official Member of BMW Club Malaysia
Download Form
Home
Forums
The BMW Range
3 Series
E36
318i e36 starts and dies
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="carlsberg" data-source="post: 626451" data-attributes="member: 21454"><p>update, stripped the car again, and cleaned everything, road test was fine, the car runs just great, but the random stalling after a hot car sitting a while is still there, ive noticed on thing though, when it does start, it does so perfectly, when its a 'stall start' it has a rattle to it, kinda like a timing chain or too far advanced ignition 'pinking' sound............ tomorrow im going to install different knock sensors and engine temp sender...... see if that changes anything.... the road test will be into KL to locate a fuel filter..</p><p></p><p></p><p>one other thing, my car should have OBD1 on it, and should show fault codes after the 'stomp the gas pedal' test...... theres no lights showing.........also, i put the car over the service pit, to check the O2 sensor, it does not have one....... did malaysian e36's of 1994 vintage come with less electronics then the euro/US version?</p></blockquote><p></p>
[QUOTE="carlsberg, post: 626451, member: 21454"] update, stripped the car again, and cleaned everything, road test was fine, the car runs just great, but the random stalling after a hot car sitting a while is still there, ive noticed on thing though, when it does start, it does so perfectly, when its a 'stall start' it has a rattle to it, kinda like a timing chain or too far advanced ignition 'pinking' sound............ tomorrow im going to install different knock sensors and engine temp sender...... see if that changes anything.... the road test will be into KL to locate a fuel filter.. one other thing, my car should have OBD1 on it, and should show fault codes after the 'stomp the gas pedal' test...... theres no lights showing.........also, i put the car over the service pit, to check the O2 sensor, it does not have one....... did malaysian e36's of 1994 vintage come with less electronics then the euro/US version? [/QUOTE]
Verification
Post reply
Home
Forums
The BMW Range
3 Series
E36
318i e36 starts and dies
Top
Bottom