It's opened for everyone I guess. Btw, an update on my issue fault code 200.133. I think I missed out these steps below. Shall try to rectify it tonight. - LoadWin32 = 1 in Ediabas.ini - Protocol translator set to "Fister" (instead of Softring) - Configure processes -- "vm not to run", "nsw set to run", "dsm set to run"
After countless hours of troubleshooting and reading, finally got DIS up and running + connected! The reason error 200.133 popped up yesterday was due to protocol wasn't set to Fister and under processes, VM was not set to off. Below are photos I took of DIS running (pardon for the quality as taken with only with a cameraphone with only the interior lighting as the light source): Auto detect works! Control module identification Live data of the engine (you are able to select which component you would like to view) AUC heating fault Now here comes the interesting part, values of ignition coil for each cylinder! Learnt from my mech that if any of these values distort too much from the rest, that particular coil is faulty.
wingzee... your prayer and hard work have finally pay off.. just go easy when you doing the coding. btw, no need to use phone camera. I always use "PrtSc" and save the pictures using "MS Paint". It will help you to recall the before and after when you make any changes to the setting.
God did answered my prayer. Dare not touch the coding yet. Shall do more reading and consult you guys once I came across anything.
Wingzee, please guide me on Friday ya.. Hope to get GT1 working too. By the way INPA gathering or TT on 12 oct is at Paparich behind quill ( BMW ) near toyota. Start at 9pm
Tried coding earlier and it just won't work. Stuck at the main page and hang the moment I clicked on car memory. Will have to consult the sifus tomorrow.